10.7.4. Replacement of the cylinder of the switch (lock) of ignition
It will be required to you: the screw-driver with a flat edge, a mm Zh2 pin.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove top …
|
3. … and lower parts of a casing of a steering column (see. "Removal and installation of casings of a steering column").
|
4. Remove understeering switches (see. "Replacement of understeering switches").
|
5. Wring out a clamp …
|
6. … also disconnect a block of a plait of wires from conclusions of a contact ring.
|
7. Turn out the screw of fastening of a contact ring …
|
8. … also remove a contact ring.
Prevention
In order to avoid damage of a contact ring of a safety cushion during its removal record a contact ring on average situation from a provorachivaniye, for example, having stuck it with a painting adhesive tape.
|
9. Disconnect a block of wires from the antenna block of an immobilizator …
|
10. … wring out the screw-driver a clamp of the antenna block …
|
11. … also remove the antenna block of an immobilizator.
Note
Further operations are for descriptive reasons shown on the removed steering column.
|
12. Insert a key into the switch and turn it in situation "I".
13. Insert a pin into the opening located in the lower part of the case of the switch, press a clamp …
|
14. … also take the lock cylinder from the case.
|
15. Install the cylinder of the switch (lock) of ignition and all earlier removed details upside-down.