For removal of the electric drive of the lock of a door of a back it will be required to you: the screw-driver with a flat edge, keys "on 8" and TORX T20.

1. Remove a back door upholstery (see. "Removal and installation of an upholstery of a door of a back").

2. Hook the screw-driver and bring out of gearing with a clamp draft of the electric drive.	3. Remove from draft on an arm of fastening of the electric drive a clamp.

4. Press a clamp of a block of a plait of wires of the electric drive …	5. … also disconnect a block of conclusions of the electric drive.

6. Turn out two bolts of fastening of the electric drive of the lock of a door of a back …	7. … also remove the electric drive assembled with an arm of its fastening from the car.

8. Turn out two screws of fastening of the electric drive to an arm …	9. … take an electric drive rod from gearing with draft on an arm …

10. … also remove a spring from an electric drive rod.

11. Install the back door lock electric drive as it should be, the return to removal.

For removal of the switch of the lock of a door of a back you will need TORX T20 key.

1. Bring out of gearing with the holder a lock drive cable cover …	2. … also take from draft a cable tip together with its clamp.

3. If necessary remove a clamp from a cable tip.	4. Remove draft from the switch basis.

5. Turn out three screws of fastening of the basis of the lock …	6. … turn a key in the lock counterclockwise …

7. … remove the lock switch basis …	8. … also remove the switch cylinder.

9. Install the back door lock switch as it should be, the return to removal.

For removal of the lock of a door of a back you will need TORX T40 key.

1. Disconnect draft from the back door lock electric drive (see above in this subsection).

2. Disconnect draft from the lock switch (see above in this subsection).

3. Press a clamp of a block of a plait of wires of the trailer switch of the lock …	4. … also separate a block.

5. Turn out two screws of fastening …	6. … also remove the back door lock.

7. Put the back door lock as it should be, the return to removal.

For removal of a latch of the lock of a door of a back you will need TORX T40 key.

1. Remove facing of the panel of a back (see. "Removal and installation of facings of a luggage carrier").

2. Turn out two screws of fastening of a latch to the back panel …	3. … also remove a latch.

4. Establish a back door lock latch as it should be, the return to removal.

5. If after installation of a latch the zakhlopyvaniye of a door is followed by blow of the lever of the lock about a latch, adjust the provision of a latch for what through openings in facing weaken two screws of fastening of a latch and, moving a latch in the cross or longitudinal direction, achieve an unaccented zakhlopyvaniye of a door. After that tighten screws of fastening of a latch.