11:13. Removal and installation of facing of a tunnel of a floor
It will be required to you: a key of TORX T25, the screw-driver with flat and crosswise edges.
Note
The seat of the driver is removed for descriptive reasons. For receiving access to fastenings of facing it is not required to remove a seat.
|
1. Accurately hook the screw-driver a first line of the top back cover of facing of a tunnel of a floor …
|
2. … disconnect a cover from facing, overcoming the elastic resistance of its clamps …
|
3. … also uncover, having moved it on the lever of the parking brake up and forward.
|
4. Accurately hook the screw-driver edge of a frame of a cover of the lever of gear shifting …
|
5. … also remove a frame, overcoming the elastic resistance of its clamps.
|
6. Turn a control lever cover the transmission inside out and lift it up the lever.
|
7. Accurately hook the screw-driver the rear edge of the top forward cover of facing of a tunnel of a floor …
|
8. … raise a cover …
|
9. … disconnect a block of a plait of wires from the lighter …
|
10. … and, having passed a control lever cover the transmission in a cover opening …
|
11. … remove it.
|
12. Turn out a bolt of fastening of a back part of facing of a tunnel of a floor to the body basis.
|
Note
Access to a bolt of fastening of a back part of facing of a tunnel of a floor is complicated by a casing of the lever of the parking brake. Therefore its otvorachivaniye requires the short screw-driver with a crosswise edge or the corresponding bat with a neck.
|
13. In a forward part of facing of a tunnel of a floor (at the left and on the right) turn out clamps of two percussion caps of fastening of side covers of facing …
|
14. … take clamps …
|
17. Accurately hook the screw-driver of edge of side covers of facing of a tunnel of a floor …
|
18. … also uncover.
|
19. In a forward part of facing of a tunnel of a floor (at the left and on the right) turn out on one top bolt and and clamps of two lower percussion caps fastenings of facing to an arm
dashboard consoles …
22. … also remove it from the car.
23. Establish facing of a tunnel of a floor as it should be, the return to removal.