It will be required to you: a key of TORX T50, the screw-driver with flat and crosswise edges.

Note Removal and installation of facings are shown on the left side of salon. Facings are removed on the right side similarly.

1. Before removal of facing of a rack of a wind window remove a doorway sealant as it blocks a facing edge from edge of a rack.

2. Accurately hook the screw-driver edge of facing …	3. … and, overcoming resistance of holders, remove facing of a forward rack.

4. Examine facing fastening, replace the broken clamps.

5. Before removal of facings of the central rack turn out the lower bolt of fastening of a seat belt.

6. Hook the screw-driver …	7. … take a decorative cap …

8. … also turn out the screw of the top fastening of facing.	9. Overcoming resistance of holders, disconnect the top facing of the central rack.

10. Pass a belt in an opening of facing and remove facing.

Note Installation sites of holders on the top facing of a rack are so located.

11. Remove a doorway sealant as it blocks a facing edge from edge of the lower facing of a rack.	12. Accurately hook the screw-driver edge of facing and, overcoming resistance of her holders …

13. … remove the lower facing of the central rack.

Note Installation sites of holders on the lower facing of the central rack are so located.

14. Before removal of facing of a forward threshold remove a doorway sealant as it blocks a facing edge from edge of a threshold.

Note For removal of facing of a forward threshold it is necessary to remove facings of the central rack.

15. Accurately hook the screw-driver edge of facing and, overcoming the elastic resistance of her holders …	16. … remove facing of a forward threshold, having brought the cowl lock drive handle out of an opening.

Note Installation sites of holders on facing of a forward threshold are so located.

17. Before removal of the lower part of facing of a back rack remove average facing of a sidewall (see. "Removal and installation of facings of a luggage carrier").	18. Cast away a pillow of a back seat and, having hooked a percussion cap the screw-driver …

19. … take it.

20. Accurately hook the screw-driver edge of facing …

21. … and, having overcome resistance of holders, remove the lower facing of a back rack.

Note Installation sites of holders on the lower facing of a back rack are so located.

22. Establish details as it should be, the return to removal.