5.9.4. Replacement of epiploons of camshafts

At detection of traces of leak of oil through epiploons of camshafts at first check whether the system of ventilation of a case is littered and whether hoses of this system are pressed, if necessary eliminate malfunction. If leak of oil does not stop, replace epiploons.
It will be required to you: all tools necessary for removal of a cover of a head of the block of cylinders (see. "Replacement of laying of a cover of a head of the block of cylinders"), a belt of the drive of the gas-distributing mechanism (see. "Replacement of a belt of the drive of the gas-distributing mechanism"), and also a key "on 19", a face head "on 16", the screw-driver with a flat edge.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Turn out all spark plugs (see. "Replacement and service of spark plugs").
3. Uncover a head of the block of cylinders (see. "Replacement of laying of a cover of a head of the block of cylinders").
4. Take off a belt of the drive of the gas-distributing mechanism (see. "Replacement of a belt of the drive of the gas-distributing mechanism").
5. Holding camshafts from a provorachivaniye a key for six-sided sections on shaft, turn out bolts of fastening of pulleys of the drive of camshafts …
6. … also remove pulleys from shaft.
7. Having hooked the screw-driver, take epiploons from nests of a head of the block of cylinders.
8. Before installation of new epiploons examine them working edges. They have to be equal, without vyryv, dents and flows of rubber. Springs of epiploons have to be whole and unextended. Oil working edges engine.

Good advice
For simplification of a press fitting of epiploons make on their landing edges small facets by means of a file or a small emery circle.

9. Establish epiploons by working edges in block head nests, accurately fill working edges on camshafts (for example, by means of a wooden stick) and press against the stop a suitable mandrel. As a mandrel it is possible to use a head of the suitable size from tool kit or an old epiploon.
10. Establish all removed details and knots as it should be, the return to removal.
11. Adjust a tension of a belt of the drive of the gas-distributing mechanism (see. "Replacement of a belt of the drive of the gas-distributing mechanism").