7.1.11. Removal and installation of a cross-piece of a forward suspension bracket

Note
It is more convenient to perform work on the elevator.

It will be required to you: keys (or face heads) "on 10", "on 13", "on 21", TORX T25, the screw-driver with a flat edge, capacity for collecting working liquid of the hydraulic booster of steering, a stripper for a vypressovka of saylentblok.
1. Establish a steering wheel in the situation corresponding to the rectilinear movement of the car.

Good advice
In order to avoid breakage of a contact disk of a safety cushion record a steering wheel from a provorachivaniye by means of the locking mechanism of the anti-theft device of the lock of ignition. For this purpose take out a key from the lock of ignition and slightly turn a steering wheel until fixing of a shaft the anti-theft device.

2. In interior of the car under the dashboard turn out a bolt of klemmovy connection of a steering shaft with shaft of the steering mechanism …

Note
Before separation of shaft mark their relative positioning.

3. … also separate shaft.
4. Establish an antiretractable emphasis under back wheels, you will hang out a forward part of the car and remove forward wheels.
5. Disconnect a tip of steering draft from a rotary fist (see. "Replacement of an external tip of steering draft").
6. Turn off a nut, take out a coupling bolt of klemmovy connection of a rotary fist and a vypressuyta a finger of a spherical support (see. "Replacement of a spherical support of a damping rack").
7. Hook the screw-driver …
8. … also remove a pillow of a suspension bracket of system of production of the fulfilled gases from an arm.
9. Holding a hinge finger from a provorachivaniye, turn off a nut of fastening of the hinge to an arm of a rack of a forward suspension bracket and disconnect a stabilizer rack hinge finger from a stabilizer bar.
10. Establish a support under a transmission case.
11. Turn out a bolt …
12. … take out it and accurately remove a support.
13. Establish under a cross-piece of a forward suspension bracket a support (for example, a hydraulic rack or a jack).
14. Turn out on both sides three bolts of fastening of a cross-piece to a body.
15. Turn out on both sides the top bolts of fastening of a cross-piece of a forward suspension bracket to a body and take them.
16. Squeeze clamps and separate drain hoses.
17. Turn out the screw of fastening of the holder of a tube.
18. Turn out a bolt of fastening of a clamp of tubes …
19. … take away a clamp …
20. … disconnect a delivery tube from the steering mechanism and merge from it working liquid of the hydraulic booster in in advance prepared capacity or muffle traffic jams.

Note
Connection of tubes with the steering mechanism is condensed with rubber rings.
Replace rings new at each separation of connection.

21. Remove a cross-piece of a forward suspension bracket assembled with the lower levers, the steering mechanism and a bar of the stabilizer, having lowered it down. If necessary remove a stabilizer bar (see. "Replacement of details of the stabilizer of cross stability"), the steering mechanism (see. "Replacement of the steering mechanism") and the lever (see. "Replacement of the lever of a forward suspension bracket").
22. In need of replacement establish a stripper and a vypressuyta a saylentblok of a cross-piece of a forward suspension bracket, having remembered situation in which it was established.
23. Press a new saylentblok.
24. Establish details as it should be, the return to removal. Tighten bolts the moment specified in the appendix 1.

Note
At installation of the steering mechanism pay attention to that the lath was on average (neutral) situation.

25. Pump over system of the hydraulic booster of steering (see. "Pumping of system of the hydraulic booster of steering").
26. Check and if necessary adjust the angles of installation of wheels in the workshop having the special equipment.