7.1.6. Replacement of a spherical support of a damping rack
If check of a support confirmed need of its replacement (see. "Check of technical condition of details of a forward suspension bracket on the car"), replace it.
It will be required to you: keys "on 15", TORX T50, a key for bolts of wheels, a stripper of spherical hinges, a drill, an assembly shovel, a drill on metal with a diameter of 12 mm.
1. Lift and establish a forward part of the car on support. Remove a wheel.
Preventions
Slow down the car the parking brake and establish an antiretractable emphasis ("boots") under back wheels.
Weaken and tighten bolts of fastening of a wheel only on the car standing on the earth.
|
2. Turn off a nut, holding the second key a coupling bolt from a provorachivaniye.
|
3. Having hooked an assembly shovel …
|
6. If the spherical support is attached to the lever by rivets (factory installation), drill these three rivets.
Good advice
It is more convenient to drill rivets on the removed lever of a forward suspension bracket (see. "Replacement of the lever of a forward suspension bracket").
|
7. If the support is attached by bolts (it already changed), turn off three самоконтрящиеся nuts, holding bolts from a provorachivaniye the second key.
Prevention
Самоконтрящиеся nuts are not subject to reuse, replace them new.
|
8. Take rivets (bolts) from openings of a spherical support and the lever, then remove a support.
9. Establish a spherical support as it should be, the return to removal.
Prevention
At installation do not damage a protective cover of a spherical support.
|
10. Having lowered the car on the earth, several times strongly rock it.
Note
After replacement of the lower lever of a forward suspension bracket check and if necessary adjust the angles of installation of wheels. Use services of the workshops having the special equipment.
|