It will be required to you: keys "on 13", "on 17", a face head "on 13", passatizh, the screw-driver with a flat edge …

… a special key for the brake pipelines "on 10".

Note Because length and a form of brake pipelines do not allow to take away the main brake cylinder forward, having disconnected it from the vacuum amplifier of brakes, so, that it was possible to remove the amplifier, it is necessary to remove the amplifier assembled with the main cylinder.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Remove screenwash (see. "Removal and installation of a trapeze of a screen wiper of a wind window assembled with a motor-reducer").

3. Remove a stopper of a tank and pump out brake fluid from a tank, for example, the big medical syringe (see. "Replacement of a tank of the main brake cylinder").

4. Disconnect a block of a plait of wires from the sensor of level of brake fluid and a hose to the main cylinder of switching off of coupling from a tank of the main brake cylinder (see. "Replacement of a tank of the main brake cylinder").	5. Turn off nuts of fastening of two pipelines to the main brake cylinder …

6. … also take pipelines aside.

Good advice Muffle pipelines in any available way (for example, having put on their ends protective caps of valves for production of air) to prevent an effluence of brake fluid.

7. Hook the screw-driver a tip of a vacuum hose and take a tip from the sealing plug of an opening in the case of the amplifier.	8. Turn out lower …

9. … and top bolts of fastening of an arm of the hydroelectronic block of anti-blocking system of brakes to body panels.	10. In interior of the car under the dashboard squeeze the screw-driver clamps of a finger of a fork of a pusher of the vacuum amplifier of a brake …

11. … also take a finger from openings of a fork and a pedal.

12. Turn off four nuts of fastening of the vacuum amplifier to a front board which are at the same time fixing and an arm of pedals …

13. … also remove the vacuum amplifier assembled with the main brake cylinder.	14. In case of replacement of the vacuum amplifier remove sealing laying from hairpins of his fastening and establish on the new amplifier.

Note Replace strongly pressed out or torn laying.

15. Turn off two nuts of fastening to the amplifier of the main brake cylinder, remove the cylinder and establish it on the new amplifier (see. "Replacement of the main brake cylinder").

16. Establish the amplifier of brakes and all removed details as it should be, the return to removal, fill in brake fluid and remove air from system (see. "Pumping of a hydraulic actuator of the brake system").