On the car apply four brake hoses: two (back) for connection of pipelines with working cylinders of back brake mechanisms and two (lobbies) for connection of pipelines with working cylinders of forward brake mechanisms.

It will be required to you: a key "on 17" …

… special keys for the brake pipelines "on 11", "on 14", passatizh.

Good advice Always apply special keys as nuts are strongly tightened and usually korrodirovana owing to what when using of usual keys of a side of nuts are rumpled to an otvorachivaniye of nuts of tubes.

Note Work is shown on the example of a forward hose. The back hoses having a similar design replace practically with the same receptions.

1. For convenience of work remove a forward wheel from the replaced hose.

2. Pick up the screw-driver …	3. … also remove a clamp of fastening of a hose to an arm on a damping rack …

4. … also take the holder of a hose from an arm.	5. Turn off a nut of fastening of a tube and disconnect a tube.

6. Take a clamp of fastening of a hose to an arm on a body, having picked up it the screw-driver.

Good advice For prevention of a full effluence of liquid from a hydraulic actuator muffle a tube opening in any available way at once. Very well protective caps of valves for production of air are suitable for this purpose.

7. Take a hose tip from an arm opening on a body.	8. Turn out the lower tip of a hose from a support, holding a hose the second key from a provorachivaniye …

9. … also remove a hose.

10. Establish a new hose as it should be, the return to removal.

Prevention Track that the hose was not overwound at installation along an axis.

11. Similarly replace other hoses.

12. After replacement of hoses remove air from the brake system (see. "Pumping of a hydraulic actuator of the brake system").