9.8.2. Replacement of a support assembled from a guide of blocks

Details of a support of the brake mechanism of a forward wheel are shown in fig. 9.5.

Fig. 9.5. Details of a support of a forward wheel: 1 – internal brake shoe; 2 – external brake shoe; 3 – guide of blocks; 4 – spring clamp; 5 – support; 6, 7 – protective plugs; 8, 9 – the directing fingers; 10, 11 – covers

It will be required to you: a face head "on 15" …
… a special key for the brake pipelines "on 14", a key for nuts of wheels, capacity for discharge of brake fluid.
1. Remove a wheel from the replaced support.
2. Weaken an inhaling of the lower tip of a brake hose.
3. Turn out two bolts of fastening of a guide of blocks to a rotary fist …
4. … also disconnect a support from a fist.
5. Disconnect a support from a brake hose, screwing together it from a hose tip, and remove a support assembled from a guide of blocks.

Good advice
Substitute capacity for discharge of the rest of brake fluid from a hose and the working cylinder of a support.

6. Establish a support as it should be, the return to removal. Before installation of bolts of fastening of a guide of blocks to a rotary fist apply an anaerobic clamp of a carving on a carving. Tighten a tip of a brake hose completely before installation of a support on a rotary fist. At installation of a support track that the hose was not overwound. After installation restore the level of brake fluid in a tank of the main brake cylinder and remove air from a hydraulic actuator of brakes (see. "Pumping of a hydraulic actuator of the brake system").