If in use appeared begin to flow brake fluid on the brake drum and inside of a wheel or jammed pistons in the cylinder, replace the working cylinder.

It will be required to you: keys "on 10", "on 14", a welding clip with fixing, a key for nuts of wheels.

1. Include the I transfer and establish an emphasis under forward wheels.

2. Remove the corresponding back wheel.

3. Clear of dirt the place of fastening of a brake hose and bolts of fastening of the working cylinder from a reverse side of a brake board.

4. Remove the brake drum (see. "Removal and installation of the brake drum").

5. Remove brake shoes (see. "Replacement of brake shoes of the brake mechanism of a back wheel").

Good advice At the known skill brake shoes can be not removed. Lift the lever of the parking brake — the top ends of blocks will depart from an emphasis of pistons.

6. Turn off a nut of a tip of a brake tube.

7. Muffle a brake tube, having put on a protective cap (for example, having removed it from the valve of production of air) its tip to prevent leak of brake fluid from a hydraulic system at removal of the working cylinder.

8. Turn out bolts of fastening of the working cylinder, holding the cylinder on the other hand …	9. … also push the cylinder in a brake board opening.

10. Install the working cylinder as it should be, the return to removal.

11. Establish brake shoes (see. "Replacement of brake shoes of the brake mechanism of a back wheel").

12. Install the brake drum (see. "Removal and installation of the brake drum").

13. Remove air from the brake system (see. "Pumping of a hydraulic actuator of the brake system").

14. Several times sharply press a brake pedal to bring brake shoes to a drum.