Note Replacement of forward seat belts is shown on the example of a seat belt of the driver. The seat belt of the forward passenger is replaced similarly.

You will need TORX T50 key.

1. Seat belts are equipped by prednatyazhitel therefore disconnect a wire from the minus plug of the rechargeable battery.

Preventions After a wire detachment from the minus plug of the rechargeable battery it is necessary to wait not less than 10 min., only after that it is possible to start removal of the seat belt equipped with a prednatyazhitel. Dismantling of prednatyazhitel of belts is forbidden. Falling of locks of belts with prednatyazhitel and hit in them of water and oil is not allowed. Influence on prednatyazhitel of belts of temperature above 95 °C is not allowed.

2. Disconnect the top part of its facing from the central rack (see. "Removal and installation of facings of salon") also pass seat belt lock language in its opening.	3. Turn out a bolt of the lower fastening of a seat belt.

Note On a bolt the remote plug is installed, do not lose it.

4. Pass the lower branch of a belt in an opening of the top part of facing of the central rack and remove the top part of facing.	5. Remove the lower part of facing of an average rack …

6. … and a forward part of facing of a threshold (see. "Removal and installation of facings of salon").	7. Turn a belt guide clockwise …

8. … shift a guide down …	9. … also disconnect a guide from a body rack.

10. Remove a guide from a belt.	11. Turn out a bolt of the top fastening of a belt and disconnect a belt buckle from a holder of knot of adjustment of provision of a belt on height.

Note On a bolt the flat washer is established, do not lose it.

12. Turn out two bolts of fastening of knot for adjustment of provision of a belt on height …	13. … also remove knot for adjustment.

14. Turn out a bolt of fastening of the inertial coil …	15. … also take the coil from a body rack.

16. For removal of the lock of a forward seat belt it is necessary to remove a seat from the car (see. "Removal and installation of a front seat"), as at the established seat there is no access to a block of a plait of wires of a prednatyazhitel of a belt.	17. Disconnect from an arm on the basis of a seat a block of a plait of wires of a prednatyazhitel.

18. Turn out a bolt of fastening of the lock of a seat belt to a seat and remove the lock.

19. Establish details as it should be, the return to removal.