11.22.3. Removal and installation of a trapeze of a screen wiper of a wind window assembled with a motor-reducer

It will be required to you: keys "on 10", "on 13", "on 27", TORX T30.
1. Remove an airinflow box lattice (see. "Removal and installation of a lattice of a box of airinflow").
2. Turn off a nut of fastening of a lead of a trapeze …
3. … also remove metal and rubber washers.
4. Turn off three nuts of fastening of a damping rack …
5. … turn out three screws of fastening of an antisplash guard to the lower part of a frame of a wind window …
6. … turn out a bolt of fastening of an arm of a screen wiper …
7. … also remove an antisplash guard.
8. Bring out of the lower part of a frame of a wind window a screen wiper trapeze assembled with a motor-reducer …
9. … wring out a clamp of a block of a plait of wires of a screen wiper …
10. … disconnect a block from a motor-reducer conclusion …
11. … also remove a trapeze of a screen wiper of a wind window assembled with a motor-reducer.

Note
The trapeze of a screen wiper of a wind window has a non-demountable design. At the raised side plays in its hinges or at damage of levers replace a trapeze assembled. The motor-reducer can be disconnected from a trapeze (see. "Replacement of a motor-reducer of a screen wiper of a wind window").

12. Establish details as it should be, the return to removal.