You will need all tools necessary for removal of forward flaps, and also face heads "on 10" and "on 13", the screw-driver with a flat edge.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Open a cowl and establish it on an emphasis.

3. Remove forward flaps (see. "Removal and installation of mudguards of wheels and flaps").

4. Disconnect blocks of plaits of wires from conclusions of fog lights (see. "Replacement of a fog light").	5. In arches of both forward wheels turn out two bolts of fastening of a bumper to its bar …

6. … and on one bolt of fastening of a bumper to forward wings.	7. From within a bumper, from its left and right side, wring out two latches of fastening of a bumper to a frame of a radiator and bring latches out of openings in a frame.

8. In the top part of a bumper wring out the screw-driver three holders on a radiator frame, bring bumper latches out of openings of holders …

Note The top holders of a front bumper on a radiator frame are so located.

9. … also remove a bumper, taking out two of its clamps on both sides (are shown on a photo by shooters) from openings in forward wings.

10. If removed a bumper for replacement, remove from it fog lights (see. "Replacement of a fog light") also establish on a new bumper.

11. Having hooked the screw-driver, take three percussion caps of fastening of two side guards of a radiator at the left and on the right …

Note Replace the damaged percussion caps of fastening of guards.

12. … also remove both guards.	13. Having hooked the screw-driver, take on one percussion cap of fastening of the lower guard of a radiator to a bumper bar at the left and on the right …

14. … also remove a guard.	15. Disconnect from the holder on a bar of a front bumper a block of a plait of wires …

Note If you remove a bumper bar for replacement, take the holder of a block of a plait of wires from an opening in a bar, having hooked it the screw-driver, and establish on a new bar.

16. … knife three collars of fastening of a plait of wires to a bar and take a plait aside.

Note Collars of fastening of a plait of wires to a bar of a front bumper of one-time use. To separate them or to take from bar openings without damage it is impossible. Therefore at the return assembly establish new collars.

17. From the inside of a radiator frame (at the left and on the right) turn out two bolts of fastening of a bar of a front bumper to it.	18. Turn out four bolts of fastening of a bar of a front bumper to body longerons at the left and on the right …

19. … also remove a bar.

20. Establish details as it should be, the return to removal.