5.6.3. Replacement of a back support of a suspension bracket of the power unit
It will be required to you: a key and a face head "on 15".
1. Establish a reliable support under a transmission case or you will hang out the power unit the load-lifting mechanism.
|
2. Turn off a nut of fastening of a block of a plait of wires of the sensor of concentration of oxygen …
|
3. … also take a block of a plait of wires aside.
|
4. Turn out a bolt of fastening of a support to an arm on a stretcher …
|
5. … also take a bolt.
|
6. Turn out two bolts and a bolt hairpin of fastening of a support to the transmission …
|
Note
The bolt hairpin intended for fastening of a block of a plait of wires of the sensor of concentration of oxygen is rolled in the corresponding opening.
|
7. … also remove a back support.
8. Establish a back support of a suspension bracket of the power unit as it should be, the return to removal.