The drive of control of the transmission consists of two cables: the choice and gear shifting, however only the cable of the choice of transfers is regulated.

It will be required to you: metal core with a diameter of 3 mm (for example, drill or long screw), ruler.

1. Remove facing of a tunnel of a floor (see. "Removal and installation of facing of a tunnel of a floor").

2. Establish a control lever by the transmission in neutral situation and record it, having inserted into a fork of a lead and into a coulisse opening a metal core with a diameter of 3 mm (this operation is shown on the removed coulisse).

3. Remove protection of a case of the engine (at its existence).

4. Uncover a gear shifting mechanism casing (see. "Replacement of cables of control of the transmission").	5. Unblock a tip of a cable of the choice of transfers for what press the tip clamp button (red color) …

6. … also nominate her from a tip.	7. Move the lever of the choice of transfers against the stop up (at the same time the tip will move up a cable too). Measure length of a carving part of a cable.

8. Move the lever against the stop down and again measure length of a carving part of a cable (the difference of two measurements and is value of a full speed of the lever).

9. Move the lever up half of a full speed and record a tip on a cable, having drowned the red button in a tip.

10. Establish a gear shifting mechanism casing cover.

11. Take from an opening of the coulisse of a control lever the transmission the fixing core.

12. Launch the engine and check the clearness of inclusion of all transfers. If necessary repeat adjustment.

13. Establish facing of a tunnel of a floor.