8.3.2. Removal and installation of a steering column

It will be required to you: keys "on 10", TORX T20, a face head "on 13".
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove a steering wheel (see. "Removal and installation of a steering wheel"), previously having established it in the situation corresponding to the rectilinear movement.
3. Remove an overlay of the dashboard (see. "Removal and installation of the dashboard").
4. Remove a casing of a steering column (see. "Removal and installation of casings of a steering column").
5. Remove understeering switches (see. "Replacement of understeering switches").
6. Wring out a clamp …
7. … also disconnect a block.
8. Turn out the screw …
9. … also remove a contact ring.

In order to avoid damage of a contact ring of a safety cushion during removal of a ring record a contact ring on average situation from a provorachivaniye, having stuck it with a painting adhesive tape.

10. Disconnect a block of wires from the immobilizator transponder …
11. … and from contact group of the switch of ignition.
12. In interior of the car under the dashboard turn out a bolt of klemmovy connection of a steering shaft with shaft of the steering mechanism …

Before separation of shaft mark their relative positioning.

13. … also separate shaft.
14. Turn off nuts …

Hairpins of fastening of a steering column are so located.

15. … also remove a steering column.

When replacing a steering column remove the ignition switch (see. "Removal and installation of the switch (lock) of ignition").

16. Establish all removed details as it should be, the return to removal.