6.1.6. Replacement of the main cylinder of the drive of switching off of coupling

It will be required to you: screw-drivers with flat and crosswise edges, passatizh, a key "on 10", a face key "on 13".
1. Remove a stopper of a tank of the main brake cylinder …
2. … also pump out brake fluid from the section of a tank of the main brake cylinder feeding a coupling switching off hydraulic actuator, for example, with the big medical syringe.

Note
The tank, the general for the main cylinders of brakes and switching off of coupling, consists of three separate sections: two for separate contours of a hydraulic actuator of brakes and one for a coupling switching off hydraulic actuator.

3. Remove the shelf of fastening of the rechargeable battery (see. "Removal and installation of an arm of the shelf of fastening of the rechargeable battery").
4. Wring out the screw-driver a clamp of a tip of the feeding pipeline of a hydraulic actuator of switching off of coupling and disconnect a hose from the union.
5. Similarly disconnect the pipeline of the working cylinder of coupling.
6. Disconnect a block of a plait of wires from the sensor of provision of a pedal of a brake and take a plait aside.
7. Having hooked the screw-driver a clamp of a block of a plait of wires of the switch of a stoplight …
8. … disconnect a block and take a plait aside.
9. Take the fixing bracket of a block of a plait of wires of the sensor of provision of a pedal of coupling …
10. … disconnect a block and take a plait aside.
11. Having squeezed clamps of a finger of a fork of a pusher of the vacuum amplifier of brakes, take a finger.
12. Turn out two nuts of hairpins of fastening of an arm of pedal knot to a body (for descriptive reasons openings of hairpins are shown on the removed pedal knot) …
13. … four nuts of hairpins of fastening of the vacuum amplifier also remove pedal knot from the car.
14. Having unbent passatizham, disconnect the ends of an ottyazhny spring from the lever of a pedal and an arm of pedal knot.
15. Having squeezed clamps of a finger of a pusher of the working cylinder of coupling …
16. … take a finger.
17. Turn out two bolts of fastening of the main cylinder of coupling to an arm of pedal knot …
18. … delay a coupling pedal a little …
19. … also remove the main cylinder of the drive of switching off of coupling from an arm of pedal knot.
20. Install the main cylinder of the drive of switching off of coupling and all earlier removed details upside-down.