11.9.10. Replacement of a window regulator of a back door
It will be required to you: the screw-driver with a flat edge, TORX T20 key.
1. Remove an upholstery of a back door (see. "Removal and installation of an upholstery of a back door").
2. Remove the loudspeaker of the speaker system from the relevant party (see. "Removal and installation of loudspeakers of the speaker system").
3. Hook the screw-driver a clamp of a block of a plait of wires of a back door, bring a block out of a rack cavity …
|
4. … separate a block …
|
5. … also push a plait of wires in a door cavity.
|
6. Unstick a cap of a technological opening from the window regulator basis …
|
7. … holding glass, press the screw-driver a plastic clamp and take a clamp from an opening in glass.
|
8. Remove the remote plug of the handle of a window regulator.
|
9. Lift glass in the top situation hands, bringing him out of a window regulator arm, and record glass the screw-driver installed in a technological opening in a forward part of a door.
|
10. Push a door lock drive sealant in a door cavity.
|
11. Turn out nine bolts of fastening of the basis of a window regulator to a door …
|
12. … disconnect the basis from a door, taking out from an opening in the basis the door lock drive …
|
13. … take away a plastic clamp of a block of a plait of wires of the lock of a door …
|
14. … disconnect a block from lock conclusions …
|
15. … also remove the window regulator basis.
|
16. Turn out two screws of fastening of a window regulator to its basis …
|
19. Establish a window regulator of a back door as it should be, the return to removal.