It will be required to you: a key "on 10", a face head "on 13", the extender.

1. Switch off ignition (if it was included) and open a cowl.

2. Weaken an inhaling of a nut of a coupling bolt of a tip of a "mass" wire …	3. … also remove a wire tip from the minus plug of the rechargeable battery.

4. Remove a protective cover of a tip of a wire of the plus plug of the rechargeable battery …	5. … weaken a nut inhaling …

6. … also remove a wire tip from the plus plug of the rechargeable battery.	7. Turn off two nuts of fastening of a clamping level …

8. … also remove a level.	9. Remove the rechargeable battery.

10. For removal of the shelf of the rechargeable battery wring out a clamp …	11. … also take aside the block of safety locks.

12. Turn out three bolts of fastening of the shelf of the rechargeable battery …	13. … two screws of fastening of the controller of a control system of the engine …

14. … bring the controller out of an arm on the shelf and take the controller aside.	15. Remove the shelf of the rechargeable battery.

16. Establish all earlier removed details upside-down. Before connection of wires smooth out plugs of the battery and internal surfaces of tips of wires a fine-grained emery paper. Connect wires as it should be, the return to removal, observing polarity. After connection of wires to plugs of the battery apply on metal tips of wires and the open surfaces of plugs a thin layer of Litol-24 lubricant or similar (copper-bearing conducting lubricants are most preferable).