For replacement of a lamp of near and far light in a block headlight execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Hook edge of a sealing cuff (for descriptive reasons these operations are shown on the removed block headlight) …	3. … also remove a cuff.

4. Disconnect a block of a plait of wires from a lamp.	5. Bring the ends of a spring clamp out of hooks on a reflector...

6. … cast away a clamp and take out a lamp.

Prevention Do not touch by lamp flask fingers as the galogenovy lamp strongly heats up and fatty spots will cause darkening of a flask. Take a lamp for a flask only in pure gloves or a pure rag. If on a lamp after all there were fatty spots, remove them with alcohol.

7. Insert a new lamp into a reflector and record it the spring holder.

For replacement of a lamp of dimensional light in a block headlight execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Hook edge of a sealing cuff (for descriptive reasons these operations are shown on the removed block headlight) …	3. … also remove a cuff.

4. Squeeze clamps and take a cartridge of a lamp of dimensional light from an opening in a reflector.	5. Take a lamp from the boss.

6. Insert a new lamp into a cartridge and establish it into place.

For replacement of a lamp of the index of turn in a block headlight execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Turn a cartridge of a lamp of the index of turn counterclockwise (for descriptive reasons these operations are shown on the removed block headlight) …	3. … also take it from a block headlight.

Note The cartridge of the index of turn is condensed with rubber laying. Replace strongly pressed out, hardened or torn laying.

4. Press a lamp, turn it counterclockwise …	5. … also take a lamp of the index of turn from the boss.

6. Establish a new lamp as it should be, the return to removal.

For replacement of a lamp of a side lamp of indexes of turn execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Remove the flap of a forward wheel from the relevant party (see. "Removal and installation of mudguards of wheels and flaps").

3. Take a side lamp of the index of turn from an opening in a wing (see. "Replacement of a side lamp of the index of turn").	4. Turn a cartridge of a lamp counterclockwise …

5. … also take it from an index lamp.	6. Take a lamp from the boss.

7. Insert a new lamp into a cartridge of the index and establish all earlier removed details upside-down.

For replacement of a lamp of a fog light execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Remove the flap of a forward wheel from the relevant party (see. "Removal and installation of mudguards of wheels and flaps").

3. Squeeze a clamp …	4. … also disconnect a block of a plait of wires from lamp conclusions.

5. Turn a cartridge of a lamp counterclockwise …	6. … also take a cartridge with a lamp from a fog light.

7. Establish a new lamp and all earlier removed details upside-down.

For replacement of any lamp in a back lamp execute the following operations.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Remove a back lamp (see. "Replacement of a back lamp").

3. Accurately hook the screw-driver clamps of fastening of the basis of a lamp to the case of the lens …	4. … also disconnect the lamp basis from the case of the lens.

5. Turn the replaced lamp counterclockwise …	6. … also take a lamp.

7. Insert a new lamp into a cartridge and establish a back lamp upside-down.

8. Replace other lamps similarly.

For replacement of a lamp in a lamp of illumination of registration plate you will need TORX T20 key.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Turn out two screws of fastening …	3. … take the lens from an adjusting opening …

4. … and, having overcome effort of spring contacts, take out a faulty lamp.

5. Establish a new lamp and all earlier removed details upside-down.

6. Similarly replace a lamp in the second lamp of illumination of registration plate.

For replacement of a lamp in an additional stoplight you will need the screw-driver with a flat edge.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Remove rubber caps.	3. Accurately press the screw-driver on the clamps located in openings take an additional stoplight from its adjusting opening …

4. … also take out a lamp from the boss.	5. Insert a new lamp into a cartridge.

6. Establish into place an additional stoplight, overcoming resistance of clamps of its fastening.

For replacement of a lamp in a forward plafond of illumination of salon you will need the screw-driver with a flat edge.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Wring out the screw-driver clamps of the lens of a plafond …	3. … also remove the lens.

4. Wring out spring contact and take the lighting lamp of salon.

5. Insert a new lamp.

6. For replacement of a lamp of individual illumination of driver's seats and the passenger execute subitem 1-3. Then, turning a lamp in the boss, take it.

7. Establish a new lamp and the lens of a plafond upside-down.

For replacement of a lamp in a back plafond of illumination of salon you will need the screw-driver with a flat edge.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Overcoming effort of a clamp, take a plafond from an opening in a car body (if necessary hook it the screw-driver).	3. Wring out clamps of fastening of a reflector …

4. … remove a reflector …	5. … and, overcoming resistance of spring contacts of a plafond, take a lamp.

6. Establish a new lamp and all earlier removed details upside-down.

For replacement of a lamp in a plafond of illumination of a luggage carrier you will need the screw-driver with a flat edge.

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Hook the screw-driver a plafond clamp, take a plafond …	3. … also take out a lamp.

4. Establish a new lamp and all earlier removed details upside-down.