It will be required to you: a face key "on 10" and a key "on 15".

1. Disconnect a wire from the minus plug of the rechargeable battery.

2. Take off a belt of the drive of auxiliary units (see. "Replacement of a belt of the drive of auxiliary units").

3. Remove the right block headlight (see. "Replacement of a block headlight").

4. Remove a protective cap …	5. … turn off a nut …

6. … also remove the plug from a conclusion "plus" the generator.	7. Press a clamp …

8. … also disconnect a block of a plait of wires from generator conclusions.	9. Turn out the lower bolt of fastening of the generator.

10. Turn off one nut and turn out one bolt of the top fastening of the generator to a head of the block of cylinders.	11. Remove the generator from a hairpin and take it through a block headlight aperture.

12. Install the generator and all earlier removed details upside-down.

Note According to recommendations of manufacturer belts of drives of auxiliary units and the pump of the hydraulic booster of steering for removal should be knifed then they become useless. This results from the fact that both belts even after removal without damage are not subject to reuse as are calculated only on one-time extension at putting on on pulleys (adjustment of a tension of belts is not provided). Besides, replacement of belts is regulated after the certain run or term of operation therefore when replacing a belt of the drive of auxiliary units at the same time it is necessary to replace also a belt of the drive of the pump of the hydraulic booster of steering.